Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

This any good for two mode driver?

Y

yew.sir-name

Guest
https://www.kaidomain.com/WEBUI/ProductDetail.aspx?TranID=2958

970mA/300mA/120mA+Strobe+SOS
- Gives 960mA/300mA/120mA/Strobe/SOS output
- 100%/35%/10% light level
- Switch light mode by tapping any reverse clicky switch
- Two seconds light mode memory
- Measures in 17mm in width, 3mm in height
- Double side gold plated - Operates from 2.6V to 6V (works best from 3.6V+) - Voltage cut-off at 2.6V with 0.08mA
- Uses three 7135 current regulated board for TRUE constant light output


good driver if the other modes are disabled and only the 120 and 300 were used?
 





Joined
Sep 25, 2007
Messages
434
Points
28
that sounds perfect for ideas i have had, I wonder what the strobe frequency is, if it is strobed on and off you could wave the laser thru the air and have an aerial display of seperate beams

it probably wouldnt be hard to figure out how to control the strobe rate

I wonder what a reverse clicky switch is supposed to be!

17mm may be just a bit too large to fit inside most of my flashlights.

This ought to be a great enhancer of sales capability if you plan on selling!!
thanks a lot for this tip!!
 
Y

yew.sir-name

Guest
They used to run the same company (fifthunit) then split into what they are today. They more than likely are the same board.
 




Top