??test if rkcsr driver is dead.

[GreenLaser]

my rkcstr driver has only been fed 7-9v and i just woud connect the output pads to my multimeter set on 200m setting it would read around 65 and i could adjust it to over 100. but now it reads nothing?? how do i test if it is dead :cryyy:

 

[Pontiacg5]

I'm not sure but I think you are not supposed to run those without a load. The multimeter might provide enough of a load to keep it going but when you disconnect the meter it would run with no load and break.

I know the boost drive cannot be run without a load, I'm not sure about the Rkcstr though. You should build a test load, you can get everything you need at radioshack very cheap or in broken electronics you have around the house.

 

[GreenLaser]

arrrr f*&k ing hell damit that friver was 30 dollars to australia.
everyone also pls visit this and have your input and tell me if this is right http://laserpointerforums.com/f44/ddl-driver-etching-50782.html
cheers

 

[chipdouglas]

you can run the rkcstr with out load but you cant test it with out a load. you need a test load so your meter can read something.

and quit asking about your driver etching....we are not lawyers. you have already been told the best advice which is to contact daedal.



michael