Switch questions

[jander6442]

I want to power 2 drivers either at the same time as well as have the ability to run them independently. I thought of hooking both to the positive with separate grounds (running a tail switch).

I'm looking at one of those 1no1nc LED switches even found a 2no2nc LED ring push button I know there is a way.

If I was using a 9mm diode with a continues ground driver could I bridge the cathode to the host and the drivers - output?.:undecided: This would keep the switches - isolated to the switch then no, no that would work.:tsk:

I need some help I want to run the diode and a tec then I want to run just the tec alone.:beer:

 

[jander6442]

Stayed tuned I guess... Trying a SPDT switch not quite what I wanted, but it's rated 14V and 5A.

 

[Bionic-Badger]

Many of those diodes have their power pins not connected to their case. Just isolate the driver from the case as well and use two separate switches.

 

[jander6442]

Many of those diodes have their power pins not connected to their case. Just isolate the driver from the case as well and use two separate switches.

I only want one switch.... aesthetics man. Thanks for the input however.