- Joined
- Jan 14, 2011
- Messages
- 3,816
- Points
- 63
Good news! I sold these. Keeping up the thread though if something bad happens.
So I decided to put up another 405nm laser for sale (I got a bunch of PHR diodes for cheap and had no use for them, so I built them into lasers so I could recoup some losses from earlier).
405nm 85mW Laser:
Picture:
LPM shot at 88mW:
Specs:
- mom-on button in the tail
- module pressfit copper heatsink
- Aixiz lens
- Duty cycle: 1 minute 30 seconds on, 30 seconds off
- Requires two li-ion batteries
Price: $40 shipped.
Alright. So they are all sold but the PHR. Going to drop the PHR price down to $40 (which is essentially at cost - $10 for the diode, $8 for the lens, $4 for the driver, $10 for the host, $5 for shipping. All in all, that cost is $37 for a laser that costs $40. Come on people, it's a great deal!
80mW Chrome LeadLight 405nm Pen
It's a sleek and sexy laser, I'm not going to lie to ya there
This laser is a tighter build and runs off of a DDL-based driver. Therefore, it's duty-cycle should probably only be 45 seconds on, 15 seconds off. It runs off of two li-ion 10440s, and is a case-negative build. Batteries will be included in the laser. The module is pressed into the pen host, so it is *not* thermally adhered (in the event that the module needs to be replaced or whatever. That said, the module shouldn't "pop out" unless you are putting undo strain onto it (like using protected 10440s or using the wrong length batteries).
Price: $40 shipped.
PM me or post here, whatever.
And pardon the crappy pictures. My camera is sorta crappy.
So I decided to put up another 405nm laser for sale (I got a bunch of PHR diodes for cheap and had no use for them, so I built them into lasers so I could recoup some losses from earlier).
405nm 85mW Laser:
Picture:
LPM shot at 88mW:
Specs:
- mom-on button in the tail
- module pressfit copper heatsink
- Aixiz lens
- Duty cycle: 1 minute 30 seconds on, 30 seconds off
- Requires two li-ion batteries
Price: $40 shipped.
Alright. So they are all sold but the PHR. Going to drop the PHR price down to $40 (which is essentially at cost - $10 for the diode, $8 for the lens, $4 for the driver, $10 for the host, $5 for shipping. All in all, that cost is $37 for a laser that costs $40. Come on people, it's a great deal!
80mW Chrome LeadLight 405nm Pen
It's a sleek and sexy laser, I'm not going to lie to ya there
This laser is a tighter build and runs off of a DDL-based driver. Therefore, it's duty-cycle should probably only be 45 seconds on, 15 seconds off. It runs off of two li-ion 10440s, and is a case-negative build. Batteries will be included in the laser. The module is pressed into the pen host, so it is *not* thermally adhered (in the event that the module needs to be replaced or whatever. That said, the module shouldn't "pop out" unless you are putting undo strain onto it (like using protected 10440s or using the wrong length batteries).
Price: $40 shipped.
PM me or post here, whatever.
And pardon the crappy pictures. My camera is sorta crappy.
Last edited:
