Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



Shortage

thedoc8

New member
Joined
Apr 21, 2020
Messages
25
Points
3
Was looking for the copper things to put the 5.6mm diode in, something with nice threads, none of the vendors hear seem to have any that size. I can find the junk ones. Someone have a tip. Thanks
 



Encap

Well-known member
Joined
May 14, 2011
Messages
5,576
Points
113
Thanks

Only 5.6 he has is the no press, are they any good, seems dissipation would not be as good. But they look nice. What is your opinion, thanks
DTR's service and modules and are the best of the best---as mentioned on that page in red font-- no diode press is needed-"

"NEW V6 12MM 5.6MM NO PRESS MOUNTS
Diode is secured in mount by thermal base of the full and half length solid copper back half. New design adds direct heat transfer from the base of the diode into the solid copper back half like the 9mm diode mounts and ease of assembly without the need for a diode press
."
 

thedoc8

New member
Joined
Apr 21, 2020
Messages
25
Points
3
DTR's service and modules and are the best of the best---as mentioned on that page in red font-- no diode press is needed-"

"NEW V6 12MM 5.6MM NO PRESS MOUNTS
Diode is secured in mount by thermal base of the full and half length solid copper back half. New design adds direct heat transfer from the base of the diode into the solid copper back half like the 9mm diode mounts and ease of assembly without the need for a diode press
."
Thanks once again, just made an order, can't wait to go blind.
 
Last edited:

gazer101

Active member
Joined
Feb 23, 2020
Messages
197
Points
43
Thanks

Only 5.6 he has is the no press, are they any good, seems dissipation would not be as good. But they look nice. What is your opinion, thanks
It was a joke right 🤔? You can't keep us hanging by a thread man (no pun intended)!
 
Last edited:




Top