ZapU
0
- Joined
- Aug 9, 2010
- Messages
- 393
- Points
- 0
If you have a G1 Arctic, it can be set up easily for remote control.
You need to take out the shunt plug and fasten a couple of contacts with 2mm screws (about 10-12mm long).
While you are modding, you can epoxy a 1/4 inch nut on the housing and make it tripod mountable.
The remote has a range of about 150 ft.
I purchased a garage door remote receiver and remote from dinodirect and connected a 9V battery to power it. Then two wires to terminals that are connected together when activated. Connect to shunt plug terminals, click on laser, and use the remote.
You need to take out the shunt plug and fasten a couple of contacts with 2mm screws (about 10-12mm long).
While you are modding, you can epoxy a 1/4 inch nut on the housing and make it tripod mountable.
The remote has a range of about 150 ft.
I purchased a garage door remote receiver and remote from dinodirect and connected a 9V battery to power it. Then two wires to terminals that are connected together when activated. Connect to shunt plug terminals, click on laser, and use the remote.
Last edited:
