Quick Review | 1W+ 635nm Bright Red Arcane - Custom Laser

[Thejoker301]

Hi ,

So as said , I got 5 of these Arcane hosts that I designed.

I had some free time today and decided to use my 635nm diode that is sitting there for over a month now

And this is the result :

It does over 1050mW at 1200mA with the 405G2 Lens

Burning video :eg:

This laser runs on 1x 18650 battery. The driver is a 5 mode driver : High ( 1200mA ) \ Med \ Low \ Strobe \ SOS

A video of the 5 modes :

The duty-cycle on it is very good. You can turn it on for like 5 minutes. But I would stick to 2 minutes for best life expectancy

Beamshot :

Mirror Polished Focus Adapter :

All in all , I really like how the Arcane host came out at the end. I redesigned it about 5 times until I got to that design with the side clicky button.

After I will build the last 3 Arcanes , I will start designing another host The Arcane might not be back for a second run.

This laser is also up on sale in my website and in the Buy&Sell&Trade Section.

Thanks for watching ! :wave:

 

[ARG]

Wow! That's a lot of power. You're one of the few in the 1W 638nm club

 

[Thejoker301]

Wow! That's a lot of power. You're one of the few in the 1W 638nm club

Lol

:beer:

 

[Blord]

You should mention the horrible bar shaped dot of the 1 Watt 638nm diode. It is far worse than the 445nm blue dot.
Also I don't consider this as a review but more as a show case of your laser.

 

[Thejoker301]

You should mention the horrible bar shaped dot of the 1 Watt 638nm diode. It is far worse than the 445nm blue dot.
Also I don't consider this as a review but more as a show case of your laser.

Yes it is more like a show case I guess

Thanks for the comment :beer:

 

[Raiden Gekkou]

Well, I just bought one. This'll be my first red since the keychain pointers from years ago.

 

[Thejoker301]

Well, I just bought one. This'll be my first red since the keychain pointers from years ago.

:beer:

 

[slyoung1987]

Wow that's ery nice and powerful 635nm laser, that host looks beautiful and especially the mirror finish around the aperture.

I've got a 638nm module in my projector and it looks very nice and a lot brighter than the 650nm in my older system.
I've been looking at buying one of these nice Reds next .

Warning noob question incoming. Is the 635nm more towards orange then the 638nm? And with just 3nm difference would you be able to notice this by eye?