Question about Osram PLP450 diode driver from DTR

[_xXx_MLG_PiNgU_69420_xXx_]

Hi, does anyone know what current is the driver set at here? (the one with a 3-element lens and a driver)

 

[Pi R Squared]

Hi, does anyone know what current is the driver set at here? (the one with a 3-element lens and a driver)

Hopefully DTR himself will be along to answer this, if he doesn't see this then you can email him at the address on the home page of his site. Since the maximum suggested current is 300mA I wouldn't be surprised if it is set at 250mA but I don't know.

Alan

 

[_xXx_MLG_PiNgU_69420_xXx_]

Thanks, I might use it for a build in a month or two but I'm kind of paranoid about the current.

 

[Pi R Squared]

Thanks, I might use it for a build in a month or two but I'm kind of paranoid about the current.

No need to be paranoid, that's not so much current. Any 18650 will last long enough at that power level. This would be perfect for a C6 build.

Alan

 

[DTR]

I use a Nano buck/boost set to 275mA. Input voltage 2V-6V.

 

[_xXx_MLG_PiNgU_69420_xXx_]

I use a Nano buck/boost set to 275mA. Input voltage 2V-6V.

Thanks, that should be ~300mW of single mode 450nm goodness

 

[_xXx_MLG_PiNgU_69420_xXx_]

No need to be paranoid, that's not so much current. Any 18650 will last long enough at that power level. This would be perfect for a C6 build.

Alan

What a coincidence, I had already planned to use a SL C6 Assembly before starting the thread