Ways
0
- Joined
- Apr 27, 2009
- Messages
- 60
- Points
- 0
I was a little bored this morning and i have a PHR 803 in Aixiz module with Flexdrive but no host as yet (i am planning on installing it in a blue/purple solitaire maglite) and so i was looking around for a temporary host for some burning fun but couldnt find anything suitable, until i spied the matchbox...
A few minutes work with a craft knife and i had a hole in one end just large enough to fit the unscrewed lens assembly, popped the lens assembly into the hole and screwed into the module until it was fairly tight.
Added a mom switch which i taped to the module body with button just above the picture of the match head on the box, added a CR2 for power, tucked in the wires closed the box, applied slight pressure and hey presto the ultimate safety match
Inside its a bit of a mess (much use of electrical tape) but it was fun and killed some time
EDIT:- not wanting to cause any member to suffer eye strain from viewing my poor quality video (and avoid any potential for litigation) i shot a better quality video.
A few minutes work with a craft knife and i had a hole in one end just large enough to fit the unscrewed lens assembly, popped the lens assembly into the hole and screwed into the module until it was fairly tight.
Added a mom switch which i taped to the module body with button just above the picture of the match head on the box, added a CR2 for power, tucked in the wires closed the box, applied slight pressure and hey presto the ultimate safety match
Inside its a bit of a mess (much use of electrical tape) but it was fun and killed some time
EDIT:- not wanting to cause any member to suffer eye strain from viewing my poor quality video (and avoid any potential for litigation) i shot a better quality video.
Last edited: