Need help attaching driver board to power source.

[jakowski321]

Recently I purchased this laser30mW 532nm Green Laser Module w TTL Modulation Slot for Stage Light Show Laser | eBay I was wondering how I should go about hooking it up to a power source and if thats all I need to get it running.
Thanks

 

[SKeeZ]

You need to get a wall wart like THIS ONE Rated for 12V @1A. this should have connects on the driver board that may or may not be labeled. a big picture of the driver board would be helpful

 

[The Lightning Stalker]

That uses what is called a JST connector. You can either harvest one from an old computer power supply
or buy them new on eBay or an electronics supplier such as Digikey or Mouser. In power supplies, that
type of plug is sometimes used for the fan. Just cut the fan wires and the end off the wall wart and
solder/heat shrink.

 

[crazyspaz]

actually, the seller sends a few of those plugs with the laser- at least they did when i got my RGB module (first they sent me some red module, which also had plugs included).

 

[The Lightning Stalker]

Well, how nice of them! Here is what o-like gave me:

 

[crazyspaz]

hahahahah epic! ^

Thanks for the laugh, Lightning!