Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

My new 445! :D (Mod please move to 445 section)

Status
Not open for further replies.





Re: Help me complete my 445! :D

Everything is correct.

IIRC DTR Uses the White wire on the diode as the Case Neutral Pin.

You have to take off the back of the AixiZ module in order for it to fit inside the C6. Then you will see if the white wire is the case pin which iam pretty sure it is. But make sure. "Iam talking about the white wire on the diode"

First Rub the Green and white wire together to discharge the Caps on the driver so it doesn't kill your diode.

Then connect your Green wire from the driver to the black wire then connect the white wire to the red wire.

You can then either tape up the white wire so it doesn't touch anything or desolder it or cut it flush to the pin its soldered too.

Put everything together.:)
 
Last edited:
Re: Help me complete my 445! :D

Thank you lazeerer! :beer:

What do you mean by "rub" the green and white together?
 
Re: Help me complete my 445! :D

Jollyrajer73 said:
Thank you lazeerer! :beer:

What do you mean by "rub" the green and white together?
Click to expand...


In other words, the white and green wire tips that are coming off the driver that would connect to your diode touch them together a few times. "Like you are shorting them together"

This will discharge the caps on the driver to make sure they are not charged up and and up killing your diode by chance.!

In other words again the striped ends of the White and green wire coming off the driver. Rub them together to discharge the caps on the driver before you connect it to the diode.

If you dont do this there is a Chance it will kill your diode.
 
Last edited:
Re: Help me complete my 445! :D

alright then

so with the LD's case pin should that be left alone, should i just do nothing at all with it?
 
Re: Help me complete my 445! :D

Yes you are correct. Dont do anything with it.:) Tape it up or cut it off as close to the pin its attached to and tap the tip or de solder it off the diode.
 
Last edited:
Re: Help me complete my 445! :D

Everything looks great, and your questions where answered by Lazereer.
So about the diode's white cable, just cut it and insulate it, so it wont short anything out.

Jim
 
Last edited:
Re: Help me complete my 445! :D

jimdt7 said:
Everything looks great, and your questions where answered by Lazerer.
So about the diode's white cable, just cut it and insulate it, so it wont short anything out.

Jim
Click to expand...

You spelled my name wrong.;)

It can get confusing since there is a company name similar to mine.:rolleyes: :D
 
Last edited:
Status
Not open for further replies.


Back
Top