LPC 826 BUILD first build

[djLscatt]

lpc 826 thanks Cajunlasers
linear driver thanks Mohgasm
660nm AR Coated Three Element thanks DTR



I made a ring with a cooper plubing tube to solder the driver

http://i47.tinypic.com/2yttqnl.jpg

http://i45.tinypic.com/29oj0p4.jpg

http://i46.tinypic.com/33o40lw.jpg

http://i47.tinypic.com/if9w08.jpg

I pressed the module in the heatsink, no set screw

just 2 cells

look at the beam shot without smoke

 

[jcclow]

Nice build!

I have to get off my lazy butt and post my recent build.

 

[Moistenator]

Nice build!

I have to get off my lazy butt and post my recent build.

:undecided: You don't have to get off you're butt to make a thread. :undecided:

Good work on the build OP! I like it!

 

[Bionic-Badger]

Those are nice photos of your floor... the back wall... the vice. But what's with that blurry red thing in the front obscuring them?

Remember to actually look at the photos you upload and see if your subject is in focus. It would also help to resize those images to something much smaller. The only extra "detail" we're seeing with those big pics is blur and sensor noise.

 

[ARG]

:undecided: You don't have to get off you're butt to make a thread. :undecided:

Good work on the build OP! I like it!

No, but taking the photos requires the butt to get out of the chair

Nice build OP! I like the press fit module, best way to do it.

 

[Moistenator]

No, but taking the photos requires the butt to get out of the chair

Nice build OP! I like the press fit module, best way to do it.

Not necessarily

 

[jcclow]

Not necessarily

Totally BUSTED by Billiam...I took all of the pics sitting down. I'm editing them now. Post to follow...sorry for sorta hijacking this thread :tsk:

 

[Moistenator]

Totally BUSTED by Billiam...I took all of the pics sitting down. I'm editing them now. Post to follow...sorry for sorta hijacking this thread :tsk:

:yh: I'll be sure to check out your thread!

 

[djLscatt]

ok it's my first post and I saw after doing the post that I had to change the size of the photos .

I forgot to tell the current of the driver : 490 MA
I promise the next thread will be better than this one