Looking for a Host

[brendon7358]

I have a 50mw green module from lazerer DIY 50mW 532nm Green Laser Module but I do not have a host I am looking to spend $15>
I need one with a button and preferably just push the module in and done
Size: Copper tube (12mm x 30mm) Circuit Broad ( 12mm x 18mm)

 

[tsteele93]

I have a 50mw green module from lazerer DIY 50mW 532nm Green Laser Module but I do not have a host I am looking to spend $15>
I need one with a button and preferably just push the module in and done
Size: Copper tube (12mm x 30mm) Circuit Broad ( 12mm x 18mm)

http://laserpointerforums.com/f64/fs-new-pen-host-kits-switch-board-spring-option-nice-22561.html

Will this work?

ts

 

[Deleted member 22482]

http://laserpointerforums.com/f64/fs-new-pen-host-kits-switch-board-spring-option-nice-22561.html

Will this work?

ts

Those black ones look cool, but the silvery ones are a bit ugly, they remind me of the presentation laser pointers you can get at any store for like $1-2.

 

[brendon7358]

http://laserpointerforums.com/f64/fs-new-pen-host-kits-switch-board-spring-option-nice-22561.html

Will this work?

ts

I don't think so it seems quite complicated. I was looking for something I could just pressfit the module in that one seems much more complicated than that. I am also looking for something that uses either AAA (which that one uses) CR123 or CR2 batts
What do you think of this http://www.ebay.com/itm/Green-Laser...084?pt=LH_DefaultDomain_0&hash=item1c2347bc34 ?

 

[Mohrenberg]

I don't think so it seems quite complicated. I was looking for something I could just pressfit the module in that one seems much more complicated than that. I am also looking for something that uses either AAA (which that one uses) CR123 or CR2 batts
What do you think of this Green Laser Pointer Housing - Host 4 your Laser Project | eBay ?

Does your module already have the driver board and the spring on it?
If so, all you'd need to do is put that black piece of plastic that comes with the kit on your module's board and slide the whole thing into the pen and you're done.

 

[brendon7358]

Does your module already have the driver board and the spring on it?
If so, all you'd need to do is put that black piece of plastic that comes with the kit on your module's board and slide the whole thing into the pen and you're done.

Yes the module has everything I need I even have that black piece of plastic from my old broken 5mw green laser.