JLSE
1
- Joined
- Dec 13, 2007
- Messages
- 3,580
- Points
- 0
Re: Lava drive DIY kit close-up pics / assembly ai
I used only what was in the pink baggie, for the load its the 68ohm resistor included. I placed one meter in series with this resistor for the current and the other meter across the the load for the voltage. The flux is something I dont have a specific remover, so 99% alcohol and a cotton swab was used. Not that I need more current than 100ma, but the testing was done at 3.0v and the host will be using 3.6v which should raise the values a little more.
I used only what was in the pink baggie, for the load its the 68ohm resistor included. I placed one meter in series with this resistor for the current and the other meter across the the load for the voltage. The flux is something I dont have a specific remover, so 99% alcohol and a cotton swab was used. Not that I need more current than 100ma, but the testing was done at 3.0v and the host will be using 3.6v which should raise the values a little more.
