Laser Module Taking out button?

[ichistar2013]

Hi, i'm new to lasers and builds and was just wondering how i could take out this button?
Here's an image of the laser module i purchased
20mW 532nm Green Laser Module (3V 11.9mm) - Free Shipping - DealExtreme
I want to take the button out so that when i connect the positive and negative wires to my 3.7v battery it will lightup.

 

[shokkunlasers]

If you can solder then just desolder it and connect the two contacts with a small piece of wire.
If you can't solder use tape to hold it down

 

[Fiddy]

simply solder a wire across the switch so it bypasses the switch.

 

[ichistar2013]

What do you mean by solder across the switch, where abouts the switch like where i press it? i'm confused lol

 

[Fiddy]

look at the diagram, there's 2 contacts on the switch, join them together, it is very simple.

same thing here bro:

 

[ichistar2013]

so i join them both together, for any side? or is there a certain side? or do i do both?

 

[Fiddy]

if the switch has 4 contacts, you could put a ohm meter across a pair of contacts and if you see it change on the ohm meter when you press the switch, use those 2 contacts.

or you could just hook the laser up to a battery and bridge out a pair of contacts, when the laser starts lasing, that will be the pair of contacts to join.

 

[ichistar2013]

Thank you so much it now works, sorry if it was annoying that i didn't understand, i am still new and learning but thanks so much guys!

 

[Fiddy]

no wukkas