I can see only little red light

[enigmahack]

Or there's a possibility that the switch itself is preventing the complete current from being pushed through the diode, which means the crystals doesn't have enough 808nm pump to lase properly.

That still doesn't make it any safer to go looking at :tsk:

 

[RA_pierce]

My laser is not burned out it works normally when I give proper push on the button. I only see red glow when I push button too gently so his laser is not necessarily burned out maybe it is just a bad electrical contact or broken switch.

My comments were directed toward FIREmateo and his reported problems.

#1 still applies to you, however.
If you have the tools, replacing the switch is pretty straightforward.