How to KILL the build in i-trust show?

[borgqueenx]

its only giving me trouble.
When i plug out the dip key board it still plays the build in show when powered.
When i pull the riya cable its playing the build in show.

The build in show doesnt have savety, thus its dangerous.

And even more fun, its hanging sometimes. when i hit the back of my projector with my finger with a bit force the build-in show scans again, and stops scanning after a second. requires another tap of my hand or finger(so it needs a shake) to start scanning again.

When i scan using the dac, i dont have these problems.

Please tell me a way to just kill the build in show. i never want to see it again.

 

[Bionic-Badger]

Is there an actual mode setting that specifies it to be turned off? As in something like a pin where it would be forced off if set, for example something connected to the interlock connection on the ILDA input?

It might be switching on because of a floating input, especially with logic levels that have a far wider logic-1 voltage bands, in which case you could add a pull-up or pull-down resistor to force whatever connection to the logic value you desire.

 

[Solonar]

If you don't want the built-in shows, why have it installed at all?

My i-trust is sitting a drawer somewhere, I've never installed it.

 

[borgqueenx]

If you don't want the built-in shows, why have it installed at all?

My i-trust is sitting a drawer somewhere, I've never installed it.

because its cheap and small.

Isnt there a way to apply a solder at a chip wich contains the show or something?
i really want that show dead, finata, gone, finished ^^

 

[Bionic-Badger]

Nope, it's in the chip's microcontroller memory. Maybe just buy a better controller.

 

[borgqueenx]

Isnt there a way to make a "if no ilda connected, power off"?

 

[Bionic-Badger]

That's what I was talking about in the first reply.

 

[hakzaw1]

:undecided::undecided::undecided:

If you don't want the built-in shows, why have it installed at all?

My i-trust is sitting a drawer somewhere, I've never installed it.

^^^ MINE TOO. Other than Borg,s Pi-trust problems (which could be part of the ongoing BorG jinx) why did you not use it. Or better still why should I not install it in my DIY rgb? I have Fb3 QS(or will once I install it)
:shhh: