Module push button jumped?Mine quit, can someone give me some trouble shooting tips, I know little but i have re moved the module and jumpered it. I did this by holding the -neg end of battery on the module spring and using a jumper form the pos + of the batt to the sink and/or diode case, got no light.
Battery shows 3 volts
above test i did should eliminate the tail switch as cause.
I might mention it quit after i may have vibrated /shocked it trying to push/tap a mounting ring to the host.
= of the batt
I was just checking the working voltage of the module i bought, it is 3.0-3.7 would batt charge of 3.8 to 4.0 be cause for concern?Yes it doesn't matter, 18650 or a 14500 will both output between 3.7-4.2V when charged.
No mate, it will be fine.I was just checking the working voltage of the module i bought, it is 3.0-3.7 would batt charge of 3.8 to 4.0 be cause for concern?
532nm 120mW Green Laser Module Green Laser Dot Module 3 0V 3 7V Spcial OFFER | eBay
Glad it all worked out for you mateThanks for help PaulorNuthn, I got it kinda by mistake, when try to test i put to much pressure and the driver went sideways and busted a diode solder joint, solder it back and noticed the solder joint for the spring looked dull so I reflowed it and now it works.
I felt something was amiss when i first put it together a couple of weeks ago as i had to adjust the diode with the set screw a couple of time before it would come on and even after it would not come on instantly when i clicked the tail cap switch.
So glad i didn't blow the diode like i have done 3 times doing another build i tried.