Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

First post, I'm making a BR laser pointer.

Alright. I've been closing every night at work, so I haven't had much time to do anything lately. But I'm off tomorrow so I figured I would get some pictures up.

Module
2012-07-27015951.jpg

2012-07-27020049.jpg

2012-07-27020235.jpg


Diodes
2012-07-27020401.jpg

2012-07-27020458.jpg

2012-07-27020437.jpg

2012-08-01012501.jpg


Powered it up with a usb cable and a 100ohm resistor. I still havent received my driver, But so far this laser produces NO HEAT. I've tried focusing it to a point and I have the smallest point an inch or a few inches out and it will not even light a match. I hope it gets hotter with the driver. Here's a pic of the usb and some beam shots.

2012-08-01012523.jpg

2012-08-01012634.jpg

2012-08-01012945.jpg


I can't really get it to focus to infinity, and when I get close I have the adjuster screwed almost all the way into the module and I get a glare off of the module, as seen in the beam shots.
 





I got my driver today(finally!). I already did some customized it a bit. I forgot to take a picture before I modded it, but here we go.

Heres the front of the board. Shows the potentiometer in the top left corner and the switch was in the middle, but I already bypassed it, with a bit of a resistor prong. I also removed the spring from the rear, because there isnt enough space inside the module for the batteries so its pointless to have it there. instead I have 3 wires coming off, 2 negative(I reused the original wires from before I had the driver, so I had a + a - and a case pin wire) and the positive.

2012-08-01230223.jpg


Now here is the back of the board, where the wires connect.

2012-08-01230241.jpg


Here is the original button(the one I bypassed) soldered inline with the negative wires. I'm going to eventually have the switch in the tail cap of my host, so I didnt need the one on the board. And the spring I removed.

2012-08-01230316.jpg


Here I'm shining it into my laser safety glasses. This is with enough power to light a match and burn black plastic. It does not fully block the light. But, condoms are not 100% effective. So as they say, no glove no love. So I will wear the safety glasses because its better than nothing.

2012-08-01230640.jpg


And here is the beam on the other side of the glasses.

2012-08-01230706.jpg
 
Reflections are your enemy lol, any white shiny stuff (inc of the fridge lol) will reflect ~80% of the light back at u, this just cuts that 80% down to a fraction of what would have hit ur eye.
 


Back
Top