Dual project-monster host finish

[trinh hong phuoc]

Hi every one
I finish host dual project theard.It is Alaskan's ideas

it use 3X26650 baterry
it is some picture about it

 

[LewDude]

Wow. Super excited to see this thing loaded up with some diodes / optics. Looks very impressive, Trinh!

 

[trinh hong phuoc]

Thank you,it going to Chris,hope he get it soon and build,many work

 

[RedCowboy]

I have not seen Chris or GSS in weeks.

 

[CurtisOliver]

I haven't seen much of Encap, Tero and Andrew either recently. I PM'd Chris and wrote on Peter's profile.
I'm sure Chris will very much be happy with that host Trinh. Another fine job!

 

[Lifetime17]

Hi,
Great work need toes it fired up, Yea haven't seen those two either Red..

Rich

 

[RedCowboy]

So it appears the diodes will mount in round copper cylinders that fit in the fixtures thus allowing for adjustment of the beam up/down via. rotation and the fixture mounting slots will allow for left/right alignment, but it looks like only 1 cylindrical pair on the way out, I think you may need to use a cylindrical pair on each laser from right out of the G2 lens as you may need to grab the beam when it's still as small as possible. Then again maybe it's not too far to fit within your c-lens ? If nubm44 they diverge rapidly as we all know. Also if using a 3.3XBE it's already a tight fit with the c-lens pair set close to the G2.

 

[paul1598419]

I know for a fact that Chris would be unhappy that you used his full name here. You should have named him by his user name or first name only. If he were here, I'm certain he would ask you to take down his name as he has had troll problems in the past and you are only helping them.

 

[CurtisOliver]

That's a good point, and although I didn't realise it was there at first it could cause problems if others have.

 

[paul1598419]

I'll email him and let him know.

 

[RedCowboy]

Ouch, yea that's not a good idea even though it's likely not a secret, did anyone message Trin ?

I will message Trin and let him know too.

 

[trinh hong phuoc]

Sorry all,i edited

 

[trinh hong phuoc]

Edited twice

 

[RedCowboy]

Hey trin, I am interested in your adjustable copper modules for 9mm diodes, I will send you a message, Thanks.

 

[trinh hong phuoc]

Okay