Aurora c6 O-Rings

[LaZeRz]

Hey forum :wave:

Just wondering which size O-rings the Aurora C6 takes

I'm planning a few builds using a C6 and one of them is going to be very special :shhh:

 

[piferal]

Which part of the flashlight?

Because this flashlight has 3 O-rings, with different sizes.

 

[Elektrotechniker]

I guess he means the one on the top where the heatsink stays in place with. Dunno if that makes any sense to you ^^

 

[LaZeRz]

hmmm, I didnt know that :thinking:

I guess the heatsink O-ring is 20mm? Not sure of the rest though...

Does anyone know the measurement for each one?

 

[piferal]

hmmm, I didnt know that :thinking:

I guess the heatsink O-ring is 20mm? Not sure of the rest though...

Does anyone know the measurement for each one?

According to my measurements is not 20mm, although I'm sure that can stretch and adapt.

In principle the heatsink O-ring is 22-23mm (aprox) x 1.5mm, here's the link if you want to buy them.

Water-tight O-Ring Seal (23mm 20-Pack) - Free Shipping - DealExtreme 23x1.5mm

But because are not expensive, I would also buy the O-Ring of 21mm x 1.5mm, to secure,
if the O-Ring of 23mm ones overtightened at closing this part of the flashlight.

Water-tight O-Ring Seal (21mm 20-Pack) - Free Shipping - DealExtreme 21x1.5mm

The other are: 17 mm x 1mm for the tail cap, and 20mm x 1mm for the top of the optics.

These are approximate measurements of the 3 O-Ring.

I hope to serve you.

 

[LaZeRz]

Thanks :beer:

+1

 

[piferal]

Thanks :beer:

+1

You're welcome, if you need anything else.....