All Copper "44" Beast!!!

[ArcticDude]

Finally got around to building this beast...

Solid Copper Tùng Laser Host
NUBM44 Laser Diode in 12mm Copper Module
Multi-Function Driver:
- Group 1: Lo(5%) > Med(40%) > Hi(100%)
- Group 2: Lo(5%) > Med(40%) > Hi(100%) > Strobe > Beacon
Sanwu X3 Beam Expander (Painted Copper)
2 Element Collimation Lens (Works Best I've Found w/ BE)
Illuminated Side Switch (White)
Reverse-Clicky Tail-Switch
Requires 2x 26650 Lithium Batteries
Weights Approximately 3 Lbs 12 Ozs (1710 Grams)
Over 12" Long (310mm)
Shined w/ Mothers Mag and Aluminum Polish
Protected w/ Renaissance Wax Microcrystalline Polish
This pointer is a monster! By far the nicest I've built.

Beam Shot <-----------

I need to get a better video when it's a little lighter outside.

View attachment 66134View attachment 66133 View attachment 66135View attachment 66136View attachment 66137View attachment 66138View attachment 66139View attachment 66140View attachment 66141

Dear Santa...
Please..

 

[GSS]

Tang is that beauty host made from red copper?

 

[BowtieGuy]

Schmackitup, I know that you're just kidding, but I agree, this monster would look even more stunning if it were gold plated.
Do any of you guys remember Minimoto Kobayashi's 24K gold plated laser project, it was a real head turner, like all of his builds!

 

[paul1598419]

Schmackitup, I know that you're just kidding, but I agree, this monster would look even more stunning if it were gold plated.
Do any of you guys remember Minimoto Kobayashi's 24K gold plated laser project, it was a real head turner, like all of his builds!

I remember that laser. It isn't very complicated electroplating something in gold, though the end result is very pleasing. I have thought about doing this with a laser host in the past. Just never got around to it.

 

[CDBEAM777]

I could have it plated gold and tell people it's 3 pounds of pure gold!!!

Hmmm...To THAT claim...I would have replied …" You are Full of 3 Pounds of _ _ _ _ ".....but....Gold plating would look NICE.. Minimoto did that AU plating deal....seem to remember it was about $ 200.....But...AU plating is the ultimate and reasonable cost finish....But...I still like CU !!!! CDB