Aixiz module dimensions?

[Pontiacg5]

I've looked everywhere but I cant find the dimensions of the front half of the aixiz module. I know the whole thing is 30x12mm, but I really only want to use the front half and I need to know exactly how deep it is.

That measurement there is all I need to know!

 

[daguin]

Quality control is not very good on them. I have found from 10.95mm-11.05mm for that measurement

Peace,
dave

 

[Pontiacg5]

That is a wide range, but I can work with that.

Thanks Dave!

 

[TTerbo]

i measured 3 of mine all 11.00mm long for that section.
cheers
p.s i used electronic vernier calipers
cheers

 

[Benm]

Maybe all of those were from the same batch then...

Tolerances arent very thight, my experience with them is similar to danguin's - about 0.1 mm variance, both in length and in diameter (the latter especially for the backside, the front part as pictured seems more consistent for some reason).

 

[TTerbo]

my 4th one is 11.01

 

[LazyBeam]

Quality control is not very good on them. I have found from 10.95mm-11.05mm for that measurement

Peace,
dave

Uhhh, if that dimension is 11mm +/- .05mm... that's a pretty good tolerance.
+/-.05mm is equivalent to a +/-.002" tolerance and that ain't too shabby at all.
FYI, the average human's hair is around .1mm/.004"

 

[Meatball]

It's just a pain when you buy these heat sinks for them, that are made to a 12mm wide module, and the module you have 12.05mm. I could think of several other people, that this happened to.