Kizdawg
0
- Joined
- Feb 7, 2012
- Messages
- 977
- Points
- 0
Here is my new mits 110 singlemode build in an Aurara SH 035 with extention and a mogasm 159ma linear driver. Thaught I would share it with ya.
This was a fairly difficult build mainly due to my driver choice but it is what I had on hand. I had to drill out the pill and extend the module part way out the end of the heatsink to accomidate the length of the mogasm linear driver I dont think this will make alot of difference in performance due to it being a low 167ma build. A round driver would have made this alot easier but unfortunately I cant get them anymore. I also needed a small spacer between the pill and the heatsink which left a small gap in the head connection I am going to try to find a smaller spacer wich would solve the problem. I cut some slots in the pill so i could use a small screwdriver to turn in the pill and I used a blank benboost round board for my battery contact. I knew buying them would come in handy and I didnt have to wreck a perfectly good led driver for it. On another note this driver seems to work with 1-14500cell as well as 2x14500cells with the extention. the driver on the testload put out 167ma with 2 cells and about 107ma with 1 cell. I hope I'm not hurting it with excess V running on 2 cells.
Well here it is with and without smoke...
Here is the raw diode output compared to a mits 300(bottom) @2'
This was a fairly difficult build mainly due to my driver choice but it is what I had on hand. I had to drill out the pill and extend the module part way out the end of the heatsink to accomidate the length of the mogasm linear driver I dont think this will make alot of difference in performance due to it being a low 167ma build. A round driver would have made this alot easier but unfortunately I cant get them anymore. I also needed a small spacer between the pill and the heatsink which left a small gap in the head connection I am going to try to find a smaller spacer wich would solve the problem. I cut some slots in the pill so i could use a small screwdriver to turn in the pill and I used a blank benboost round board for my battery contact. I knew buying them would come in handy and I didnt have to wreck a perfectly good led driver for it. On another note this driver seems to work with 1-14500cell as well as 2x14500cells with the extention. the driver on the testload put out 167ma with 2 cells and about 107ma with 1 cell. I hope I'm not hurting it with excess V running on 2 cells.
Well here it is with and without smoke...
Here is the raw diode output compared to a mits 300(bottom) @2'
Last edited:
