Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

445nm 447nm 450nm 1W Wiring.....

G

gillbates

0
Joined
Nov 26, 2014
Messages
6
Points
0
I do not understand how to hook this up exactly. I know the - + at the top connect to laser diode but don't I need a negative input from the battery somewhere? I tried to using + but it didn't work? What am I doing wrong...
 

Attachments

  • walye2.jpg
    walye2.jpg
    65.5 KB · Views: 99





First picture top center pad appears to be the negative for battery. It has a - right under it. Right above U1. It also has the same type Dot on it like the negative for the LD. Have you built a test\dummy load? Do you have a dmm? Is the pot turned all the way off/down? Does it ohm out?
 
Last edited:
This is how it is currently wired. The two wires on the left are going into the diode. Am I missing something?
 

Attachments

  • fuckingwalye.jpg
    fuckingwalye.jpg
    155.7 KB · Views: 124
gillbates said:
This is how it is currently wired. The two wires on the left are going into the diode. Am I missing something?
Click to expand...

You were not consistent with your wire coloring. You have negative as purple/black on the LD side and you have it opposite on the battery side. I have heard that switching polarity can destroy things.
Also edit your prior posts to avoid double posting. (I'm not trying to be rude, I have seen other threads where mods/admins give out warnings)
 
Last edited:
Yea I know. I soldered the wrong wire to the positive but did not hook it up to the battery that way so the polarity didn't change. I'm just not sure why this laser isn't lighting up. I can plug in the battery and get a .1v at the diode output with the battery is hooked up. Something seems to be adjusting the voltage incorrectly.
 
That is a boost driver from Lily Electronics and has no reverse polarity protection.

Alan
 
Trendkilla254 said:
Potentiometer?
Click to expand...

Checked it seems to work ok. I'm not an electrical expert but I thought I was following everything correctly. With this board I should be able to wire the diode into the board and connect the battery and it should light up right?
 
gillbates said:
Yea I know. I soldered the wrong wire to the positive but did not hook it up to the battery that way so the polarity didn't change. I'm just not sure why this laser isn't lighting up. I can plug in the battery and get a .1v at the diode output with the battery is hooked up. Something seems to be adjusting the voltage incorrectly.
Click to expand...

You didn't power this on and test it with your DMM without having it connected to a test load or to the diode did you? You can only do that with a linear driver only.

Alan
 
I wired everything up plugged it in correctly no light. connected the DMM to the diode outputs and got a reading of .1V
 
You must log in or register to reply here.





Back
Top