loreadarkshade
Well-known member
- Joined
- Dec 14, 2020
- Messages
- 336
- Points
- 63
You have to make sure to change the shunt resistor on the boost driver to output 105mA for the 488nm diodeI ended up doing the same after seeing this since I have a few spares. Not sure the driver is the best for these, the diode I used normally clocks in around 489nm but it's pushing 492nm on the crap driver. Typically see that with CV sources being above the diode's rating and creates excess heat... would recommend using a better driver and desoldering the rest of the crap driver minus the button.