WTB HeNe Power supply

[norbyx]

I am looking for a power supply that works with this tube:
05-LHR-991 MELLES GRIOT
the specs of it are the following:


Minimum e/2 c/2L Supply Nominal
Output Beam Diver- Mode Opr/Strt Tube Tube Size Power Diam gence Spacing (Rb=75K) Current Diam/Lgth

10 mW .65 mm 1.24 mR 341 MHz 2.64/10 kV 6.5 mA 37/440 mm

 

[bloompyle]

Anything that outputs 6.5mA and 2.6kV will work.

That's a nice 10mW tube, that's if it does that much.

 

[pschlosser]

i have tubes of this size and type. The lase with anything in the ballpark:

1800-2600 VDC, > 6.0mA

What is your budget, Norbyx? I have more tubes than PSUs, but for the right price, I may be persuaded to part with one.

Further, what about input voltage? Living in Costa Rica, are you looking for 220VAC input? Or will 5VDC, 12VDC and 24VDC also work for your needs?

 

[bloompyle]

I should add to that, yes it will lase with anything in that range, but the closer to 2.6kV and 6.5mA you get, the better.

 

[norbyx]

My local voltage is 110-120v my bugget not too high since I spent too much money on lasers lately, I usually don't like to make offers,'so if interested shoot me a price on the PS and we can go from there.

 

[ultimatekaiser]

I got one for my friend from merideth instruments'site: Meredith Instruments : HeNe Power Supplies - The source for laser surplus

Now and then ebay has a good one pops up too, depends on your budget and how fancy you want it. If any thing it's a not half bad resource for a make and model index...

Hope that helps.