Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

What would happen

Gappa

0
Joined
Aug 14, 2010
Messages
94
Points
0
If I took the stock arctic battery and swapped it for 2 cr123 batteries?
the stocker is like 4.7v and the 2 cr123's would be 6v.
Would it blow the driver?
 





Knowing how crappy Wicked builds are lately... Yes.
 
If I took the stock arctic battery and swapped it for 2 cr123 batteries?
the stocker is like 4.7v and the 2 cr123's would be 6v.
Would it blow the driver?

The Stock Battery fully charged is 4.2Volts
2pc CR123 will be 7.2 Volts Fully Charged...

Your math is a bit off.....................

I wouldn't try it....
Would you start your car with a 24 Volt battery...:thinking:

Jerry
 
You'd be going 1.8V over the recommended voltage for this laser. you probably should just stick to Li-Ion 18650's.
 
What would happen?

The increased voltage going into the driver, and subsiquently, the diode, would increase the power output exponentially. When turned on, the Laser would set the air on fire, creating a plasma stream that would in turn set the local atmosphear on fire and create a wormhole into a alternate relaity. Everything in the local vasinity would get sucked into the event horizon of the wormhole and tranported to the otherside, where matter would re-intigrate into it's prevous form, crushing the matter that was already there. Subsiquently this would create a paradox because it would destroy the other "you" on the other side, creating a unequal balances between dimentions. Then the Entire universe would be destroyed.
:lasergun:

All because you used CR123A batteries instead.. :gj:


Or


The Diode will turn on and quickly degrade and go LED on you ;-)
 
...crushing the matter that was already there.

Crushing matter? I call BS on that one. I don't believe you.

That would be impossible.

The worst that could happen would be that you would damage the driver... which would damage the diode. Is it worth the risk to you?
 
Holy dog doo! Do you think I could just create a stable wormhole allowing me to travel to millions of different planets instantaniously! Reconnect the ZPM Rodney! The CR123's are overloading the power conduits.
 
Crushing matter? I call BS on that one. I don't believe you.

That would be impossible.

The worst that could happen would be that you would damage the driver... which would damage the diode. Is it worth the risk to you?

Sorry, crushing is not the correct term. The word crush would supposed that the matter is materialize on top of the alternate matter, then dropped. Since the matter in the original reality will be transported to the same state in the alternate reality, Nutron's law of wormhole physics dictate that the 2 matter states will exist in the same space at the same time. This will then result in a quantum state, which will result in the destruction of the alternate matter to allow the new matter to re-integrate. Since mater can not be created or destroyed the alternate matter will be transpored not my desk, and then I'll be a free arctic... :-)
 
The Hordes of Chaos have waited over a Millenia for someone to rip the fabric and open the gates of space time, and allow them to pour forth onto the Earth once again.

Last time it was a foolish feat of Necromancy that did it, combined with some ancient Sumerian tablets.

Now they bide their time, and wait for men to do it again, but with SCIENCE!

Do not give them that chance.
 


Back
Top