I got a 2.4a driver installed in a host that is currently connected to my test load.
I know for a fact that the driver is not grounding out anywhere but maybe I have the wrong setting on the test load, I dont know.
But when my host is turned on, my meter reads 2.35, then about 5 seconds later it just slowly drops to 0.
I am using the 3A selectable test load and 2-3.7v batteries to power the host.
The jumper pin on my test load is set to use 3 diodes.
I plan on using the 9mm 445 laser diode in this host again with a 2.4a x-driver
I know for a fact that the driver is not grounding out anywhere but maybe I have the wrong setting on the test load, I dont know.
But when my host is turned on, my meter reads 2.35, then about 5 seconds later it just slowly drops to 0.
I am using the 3A selectable test load and 2-3.7v batteries to power the host.
The jumper pin on my test load is set to use 3 diodes.
I plan on using the 9mm 445 laser diode in this host again with a 2.4a x-driver