Substitute Lens for Aixiz

[Brown_Wigga]

Is their another lens that I can use as a substitute for the aixiz module lens because the burning power sucks and I have to refocus it every 5 seconds.

 

[elitesniper]

well maybe you should put some teflon tape around the threads so it wont move around anymore and it wont need to refocus much and have you done the mod to the back of the lens modual?

 

[Brown_Wigga]

Yeah, but I scratched the lense alittle bit. I will probably buy a new one but if their is a better lense out than I'd rather buy that.

 

[sk8er4514]

Meredith lenses are better, but cost like $50 each.

Aixiz is the best for cost / power ratio.

thanks,
Kendall

 

[Viracocha]

You could always get a glass lens for it like the one at www.laser-sur-plus-parts.com (other retailers exist but this link was at hand, remove the -)

Or maybe use some optics from a sled as they seem to be coated glass, however i doubt they are normal collomating lens and they won't fit an aixiz.

 

[lasersbee]

You could always get a glass lens for it like the one at www.laser-sur-plus-parts.com (other retailers exist but this link was at hand, remove the -)

Or maybe use some optics from a sled as they seem to be coated glass, however i doubt they are normal collomating lens and they won't fit an aixiz.

It looks like Laser_Sur-plus_Parts.com has been Banned... I can't find that Sales Thread
or any of my posts on that thread...
I didn't see (or maybe I'm looking in the wrong area) any announcements about this ban...

Or maybe I'm the only one that can't find that Sales Thread... :-? :-? :-?

Jerry

 

[Krutz]

indeed, have a look at the optics section, at least two threads about using optics right from a sled.
i assume you have a red laser?
-get the AR-coated lens from ebay "virtualvillage" or similar. beware of the possible shippingcosts!
-use the stock aixiz lens

in fact, i only found a max of 10% increase (or less) when switching from the aixiz to the virtualvillage one. the scratch could easily cost you more %, try a fresh lens first. oh, for refocussing: the spring inside should prevent that? is it missing? you can longen (?) the spring, so it pushes harder against the lens..
teflon tape: be sure to not get any teflon between the lens and diode! if its an open can, i wouldnt use any at all, by screwing the lens you will have tiny pieces of the tape falling and messing on the diode!

manuel