JLSE
1
- Joined
- Dec 13, 2007
- Messages
- 3,580
- Points
- 0
The laser outputs just over 600mW and can be run for long
periods without the worry of overheating. The copper heatsink
does an excellent job of drawing off the heat from the LD out
to the aluminum fins.
The focus knob can be operated with one finger and has a nice
smooth action. It is also receded so if the laser is ever dropped
the brunt of the force would be taken by the body with the optics
protected.
The laser is solid and heavy. No rattling nothing fits loose.
Battery compartment has a polished sleeve which
fits tightly to an 18650. The sleeve is permanently fixed
and cannot be removed. A single 16340 could also be used,
but a spacer would have to be improvised. This is a 3.6v
max rated, using 2 x 16340's would kill it DO NOT TRY!
Details:
-A-130 LD
-Aixiz glass lens
-Pyro-Boost driver
-18650 single batt. (Not Included)
-Copper heatsink
-Rear tail clickie
-Large focus knob
-Finned exterior heatsink
-Royal blue anodized finish
*Note, there are a few imperfections in the dye. There are a few
spots where the dye did not take, but nothing really bad.
Otherwise there are no scratches etc. The metal was polished
prior to the 'failed' dye process.
Total weight with 1x 18650 lithium - 8.1oz (battery not included)
Total run-time on this laser is less than 10mins. As seen in the graph, the laser
can be run almost 10mins before the head even starts to get warm.
Selling with a full 1year warranty, full coverage.
Unfortunately I do not have any soft carry pouches for this. Its too wide for
the ones that I do have..
Asking $249. US, OBO. shipped Express in Canada, and 4 day Expedited to the US with
tracking. Guaranteed delivery to anywhere.
periods without the worry of overheating. The copper heatsink
does an excellent job of drawing off the heat from the LD out
to the aluminum fins.
The focus knob can be operated with one finger and has a nice
smooth action. It is also receded so if the laser is ever dropped
the brunt of the force would be taken by the body with the optics
protected.
The laser is solid and heavy. No rattling nothing fits loose.
Battery compartment has a polished sleeve which
fits tightly to an 18650. The sleeve is permanently fixed
and cannot be removed. A single 16340 could also be used,
but a spacer would have to be improvised. This is a 3.6v
max rated, using 2 x 16340's would kill it DO NOT TRY!
Details:
-A-130 LD
-Aixiz glass lens
-Pyro-Boost driver
-18650 single batt. (Not Included)
-Copper heatsink
-Rear tail clickie
-Large focus knob
-Finned exterior heatsink
-Royal blue anodized finish
*Note, there are a few imperfections in the dye. There are a few
spots where the dye did not take, but nothing really bad.
Otherwise there are no scratches etc. The metal was polished
prior to the 'failed' dye process.
Total weight with 1x 18650 lithium - 8.1oz (battery not included)
Total run-time on this laser is less than 10mins. As seen in the graph, the laser
can be run almost 10mins before the head even starts to get warm.
Selling with a full 1year warranty, full coverage.
Unfortunately I do not have any soft carry pouches for this. Its too wide for
the ones that I do have..
Asking $249. US, OBO. shipped Express in Canada, and 4 day Expedited to the US with
tracking. Guaranteed delivery to anywhere.
Last edited:
