PL520/Solid Brass Ehgemus Pen

[Lifetime17]

Hi,
This solid brass pen is made by Ehgemus clicky rear Threaded heat sink. it wasn't threaded for a 4-40 set screw because he thought it would be a Thermal adhesive build. I personally don't like permanent residents, i need flexibility for if and when.No biggie i drilled and tapped it for a 4-40 brass set screw to match the host. Well hope you like it folks enjoy as i enjoy sharing my builds..
In it is::
A solid brass Ehgemus host
X Drive Boost set to 2.25mA to play it safe..
G2 lens
1-14500 Efest Cell
Well here are some pics folks

Rich

 

[Isaac Clarke]

that is so cool!!! i'm guessing you gonna start building exotic wavelength into custom host, like 488;556;561;589;593; .....

 

[Jersagfast]

Nice build, you are truely on a roll. It's crazy how much you can do in one day.

Thanks,

 

[Lifetime17]

Hi FU,
we will see how things go one WL at a time. I enjoy the basic WL's that's plenty for me for now.
Rich

@ Jersag,
I had the parts laying around for a while ,it's just time to think what will work with what.
Rich

 

[Hibro]

Very lovely pen. Do you have a 532nm green laser to make the comparision?

 

[GSS]

Nice build, you are truely on a roll. It's crazy how much you can do in one day.

Thanks,

Tell me about it

 

[Lifetime17]

HI,
No i don't have a 532nm i used to but i gave it to a nice gentleman who would give it a good home . It did around 80mW's so comparing is a no go. Thank you for checking out my build glad you enjoyed it Pal..
Rich

@ GSS,
I was on Vacation so i had a little time this week, Relaxing to build a few lasers.
Rich