- Joined
- Nov 22, 2010
- Messages
- 4
- Points
- 0
I am looking to experiment with attaching a laser to my machine to hopefully help driving a straight line. It would be best if I can see the entire laser beam, not just a dot. I would need it to extend around 500ft - 1,000ft. The machines grind up asphalt from the roads, so it is very rough conditions. There is a lot of dust & vibrations. I could build a rubber mounted bracket to eliminate most of the vibration though. There are many times where the stripes on the road are not straight. I was thinking if a put a laser on as a guid it would help out tremendously. I'm sure by now you can tell I am very new to lasers. I would appreciate any ideas or suggestions offered. Since this is more of a test right now, I would prefer to keep the cost down as much as possible.
Thanks again,I look forward to your feedback.
Thanks again,I look forward to your feedback.