EzPk0970
0
- Joined
- Jan 10, 2010
- Messages
- 482
- Points
- 0
Hey guys, so about 2 or 3 weeks ago I got my first lathe and have been playing with it ever since. As tonight came to a close I finally finished my first custom heatsink. I have to admit it's very exciting learning new things, especially things you can do with your hands. I took a couple pictures I hope they're not too big, but I just wanted to share this first victory with you guys =D
(who doesn't like to show off their new shiny laser?!)
Anyways, some specs are:
-Flexdrive V5 that I'm not sure of the mA because I lazily just eyeballed it after I set it at I think 200mA before and didn't want to desolder and test everything all over again. *-.- ..
-mW output is around 720ish
- Just using the AixiZ red glass lens for now.
Overall I'm very happy with it and think it's a good first victory as everything is a very snug fit. No rattling or loose parts anywhere.
Any comments or suggestions or whatever are welcome =D
(who doesn't like to show off their new shiny laser?!)
Anyways, some specs are:
-Flexdrive V5 that I'm not sure of the mA because I lazily just eyeballed it after I set it at I think 200mA before and didn't want to desolder and test everything all over again. *-.- ..
-mW output is around 720ish
- Just using the AixiZ red glass lens for now.
Overall I'm very happy with it and think it's a good first victory as everything is a very snug fit. No rattling or loose parts anywhere.
Any comments or suggestions or whatever are welcome =D
