hello. i just recieved today my 1W 445 nm laser and 200 mW violet laser.
this one: LZCB - 405nm 200mW Water Proof Violet Laser Pointer
the thing is that it dose not work with the battery inserted "+" side up, like the green and blue lasers i have. it did not came with a instruction manual, so i put the battery as i knew, 1 x 18650 3.7 volts "+" side up, and nothing.
i tought the laser is dead. after i was about to stop trying (to screw and unscrew the tail cap, recharged the battery to full capacity) i tried to put the battery "-" side up. it works. it has a dime dot, but it works. i gues its somewhere around 10-20 mW. it dose not smoke black plastis with focus. so its verry dime.
after this, i said its the diode damaged or something is wrong with the power source, so i tried the 2 x 16340 (3.7 volt each). i turned it on for a fraction of a second and it was bright. for sure 200 mW bright.
the question is: could it be the driver set to work on 2 x 16340 ? why is it outputing 10 mW with the specified 1 x 18650 3.7 volts battery and why dose it work with battery "-" side UP ? will i destroy the diode if i use 2 x 16340 ? or should i try some 2 x CR123A batterys (3 volts each) so the diode will still have some overhead?
this one: LZCB - 405nm 200mW Water Proof Violet Laser Pointer
the thing is that it dose not work with the battery inserted "+" side up, like the green and blue lasers i have. it did not came with a instruction manual, so i put the battery as i knew, 1 x 18650 3.7 volts "+" side up, and nothing.
i tought the laser is dead. after i was about to stop trying (to screw and unscrew the tail cap, recharged the battery to full capacity) i tried to put the battery "-" side up. it works. it has a dime dot, but it works. i gues its somewhere around 10-20 mW. it dose not smoke black plastis with focus. so its verry dime.
after this, i said its the diode damaged or something is wrong with the power source, so i tried the 2 x 16340 (3.7 volt each). i turned it on for a fraction of a second and it was bright. for sure 200 mW bright.
the question is: could it be the driver set to work on 2 x 16340 ? why is it outputing 10 mW with the specified 1 x 18650 3.7 volts battery and why dose it work with battery "-" side UP ? will i destroy the diode if i use 2 x 16340 ? or should i try some 2 x CR123A batterys (3 volts each) so the diode will still have some overhead?