abikutn
0
- Joined
- Oct 30, 2012
- Messages
- 37
- Points
- 0
Hello.
I am working on a multi-spectral Project, I use 445,405,638,660nm lasers.
The input to these laser drivers are pulsed and I was trying to find a laser driver that can be used to amplify the output side by varying resistor values on the driver board ( Potentiometer probably ) ...
Something like the board that can be seen in the attached pdf.
Advice and suggestions please :undecided:
I am working on a multi-spectral Project, I use 445,405,638,660nm lasers.
The input to these laser drivers are pulsed and I was trying to find a laser driver that can be used to amplify the output side by varying resistor values on the driver board ( Potentiometer probably ) ...
Something like the board that can be seen in the attached pdf.
Advice and suggestions please :undecided: