well I only have experience on his 50mw green and 100mw red labs (both of which are way over spec when measured with coherent lasercheck) The supplied driver board is auto sensing from 90-240V AC . 50-60Hz. He supplies a cable which plugs direct onto the driver board. It has a red and black wire, that you incorporate into your own domestic style plug socket. You simply plug in and go. The other supplied cable is for TTL modulation that used 0-+5 V dc for TTL modulation (blanking) if you want to incorporate it into a laser show.
With good heatsinking, Duty cycle is advertised as 4 hours constant on, with forced air or Tec cooling, I would imagine longer. I took the liberty of adding a 1Kohm pot in series, to give me 0-100% power, so i never have to drive them to full if I dont want them. Additionally there is a big blue pot on the driver board that will adjust the power further, but I would not recommend that, without some very robust cooling.
Hope this helps.
jase
With good heatsinking, Duty cycle is advertised as 4 hours constant on, with forced air or Tec cooling, I would imagine longer. I took the liberty of adding a 1Kohm pot in series, to give me 0-100% power, so i never have to drive them to full if I dont want them. Additionally there is a big blue pot on the driver board that will adjust the power further, but I would not recommend that, without some very robust cooling.
Hope this helps.
jase