Nprlaser
0
- Joined
- Jul 5, 2013
- Messages
- 158
- Points
- 28
Just got a green 532nm laser module from karlsson robotics. I'm not sure what to do with it later but for now I dropped it in a c6 host and so far it works off of 400mA at 3.7 volts. I think this laser is outputting well over 50mW, but for a $15 module, that's pretty good.
This laser must run off of 3.7volts to get a maximum output. Not only that I bridged/jumped the input resistor that feeds the current to the lm385 op amp to let the laser run more efficiently. I'm not sure why the manufacturer decided to put a resistor before the lm385 circuit. I think it was a little redundant. Here are the pics:
You can get this module here Components :: General :: Laser Module - Green
The beam specs on this laser is fantastic for a $15 module, this dot is 25 feet on the wall and the shape is a tight circle! Very good job on the manufacturers side!
Here's the module in a polished c6 host with a nice beam shot.
All the parts put into this build, pretty simple.
Overall I'd give this laser a 9/10 for its quality.
This laser must run off of 3.7volts to get a maximum output. Not only that I bridged/jumped the input resistor that feeds the current to the lm385 op amp to let the laser run more efficiently. I'm not sure why the manufacturer decided to put a resistor before the lm385 circuit. I think it was a little redundant. Here are the pics:

You can get this module here Components :: General :: Laser Module - Green



The beam specs on this laser is fantastic for a $15 module, this dot is 25 feet on the wall and the shape is a tight circle! Very good job on the manufacturers side!

Here's the module in a polished c6 host with a nice beam shot.


All the parts put into this build, pretty simple.




Overall I'd give this laser a 9/10 for its quality.