Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers
Buy Site Supporter Role (remove some ads) | LPF Donations
Links below open in new window
FrozenGate by Avery
Is this right?
- Thread starter Kaspar389
- Start date
- Joined
- Sep 7, 2007
- Messages
- 634
- Points
- 0
Kaspar no offense man but why would you want to slowly kill your LD? Just go here----->> http://www.laserpointerforums.com/forums/YaBB.pl?num=1185701612
And if that isn't enough head here: http://www.laserpointerforums.com/forums/YaBB.pl?num=1189718300
And if that isn't enough head here: http://www.laserpointerforums.com/forums/YaBB.pl?num=1189718300
Well, Im using a minimag for my first project.
That wont fit into a minimag...lol.
For my next project(when I get some more money, gatta mow some lawns or somthing" Ill make that.
Around 10 dollars right? Im almost sure ill get confused as hell on it, can you help me when I start it?
That wont fit into a minimag...lol.
For my next project(when I get some more money, gatta mow some lawns or somthing" Ill make that.
Around 10 dollars right? Im almost sure ill get confused as hell on it, can you help me when I start it?
- Joined
- Sep 7, 2007
- Messages
- 634
- Points
- 0
Yes I would be happy to help you with it when you get started. I am just going to warn you again though. If you buy an LD from Senkat, and hook it up without Daedal's circuit, you're most likely gonna have a $17 LED sooner than later. But PM me when you wanna start the circuit. It is a load of fun to make and works wonders for an LD.
Check out my minimag guide using your cap and resistors circuit.
Your cap might or might not fit though into the minimag.
This circuit is good enough for a minimag and mine burns chocolate, black tape, etc fast and does not overheat even though I left it running for a few minutes at a time.
You might want to increase the resistance slightly. 300mA CW is too high. Aim for ~160mA like Gazoo suggests. Burns well enough for me.
There isn't really much space in the minimag but I am too lazy to get a dorcy or find a torch that will fit daedal's circuit
Your cap might or might not fit though into the minimag.
This circuit is good enough for a minimag and mine burns chocolate, black tape, etc fast and does not overheat even though I left it running for a few minutes at a time.
You might want to increase the resistance slightly. 300mA CW is too high. Aim for ~160mA like Gazoo suggests. Burns well enough for me.
There isn't really much space in the minimag but I am too lazy to get a dorcy or find a torch that will fit daedal's circuit
