Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers



Laser Pointer Store

Help with AliExpress Driver

Status
Not open for further replies.
Joined
Apr 15, 2018
Messages
1
Likes
0
Points
0
Hello,

I want to build a Laser Pointer with the PLTB450B Diode. I ordered this Driver from AliExpress:

445nm 520nm 1W 1.6W 3W Laser Diode Drive Driver Board PCB 6 14V Voltage Input-in Replacement Parts from Consumer Electronics on Aliexpress.com | Alibaba Group

I send them a massage that i need it for a 1.6w Diode.
on the one side they solderd a R470 resistors in parallel (ontop of) the the R200 resistor. And they send 3 R300 resistors. Do they need to be solder all in parallel on the other side on the free solder Pads ? When i solder in one of the R300 resistors the current is to hight (over 200ma but the Diode is rated for a current of 167ma. Does soldereing the resistors in parallel in a lower Output current ?

I hove you understand my Problem and someone is able to give me an advice.

Thanks, Jonas
 
Last edited by a moderator:

Joined
Feb 21, 2016
Messages
475
Likes
273
Points
0
first you should introduce yourself in the welcome section and tell about your location.

as for your problem i don't get the part of 167ma,you need around 1.5-1.8A to drive this diode over 1.5w
 

Encap

Well-known member
Joined
May 14, 2011
Messages
4,577
Likes
1,395
Points
113
Status
Not open for further replies.




Top