Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

How to Register on LPF | LPF Donations

heatsinks

jake21

0
Joined
Dec 2, 2007
Messages
3,189
Points
0
hi im going to have heatsinks made i was woundering if any one would be enterested in some at 12.50 a peice ill have pictures soon or later today
 





he is the picture of the heatsink im having done it fits snug around the Aixiz casing let me no if any one would be enterested in some
 

Attachments

  • heatsink.JPG
    heatsink.JPG
    19.5 KB · Views: 76
here is the picture jake sent me they look great :)
 

Attachments

  • heatsink1250.jpg
    heatsink1250.jpg
    40.2 KB · Views: 132
the current heatsinks are 1 9/16 long, 3/4 diameter and 19/64 hole
 

Attachments

  • casing2.jpg
    casing2.jpg
    2.1 KB · Views: 81
What are they made out of? I'm guessing aluminum but wanted to make sure. Do you have any that would fit over just the front portion, as I usually don't use the rear of the module? I'd rather buy a shorter one for $5 shipped. As I usually snag ones out of old PCS and grind em down, or buy the ones at radio shack for $2 and drill/grind those.
 
give me measurements on what u want and how many and ill check on it for u i think i can get shoter ones to let me no what size u need
 
jake21 said:
give me measurements on what u want and how many and ill check on it for u i think i can get shoter ones to let me no what size u need

Diameter: 17mm
Length: 30mm

It all depends on how much it will cost, I checked out the radio shack ones mentioned above. I have the choice of one that will fit perfectly or a very cheap one that I will have to do work on for it to fit nicely.
 
well after i get a few orders ill give my email address and u can pay threw pay-pal or money order and ill post it when they are all made and in my hands for faster shipping
 
jake21 said:
the current heatsinks are 1 9/16 long, 3/4 diameter and 19/64 hole

can you verify 19/64 hole size? :-/ 19/64 inch=7.54mm.
the collimation housing OD is 11.80mm, the hole will needs to be bigger than 7.54mm.
 
well that an example that i put but it will be 17mm the same size of a axiz casing ir if u need a certain size i can have it done to just let me no how many and what sizeu looking for and ill check on it
 


Back
Top