Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

Heat sink on dorcy build

Joined
Mar 27, 2009
Messages
24
Points
0
Hey,

So, I'm slowly piecing together my first DIY laser, and it's in a dorcy. When I go to put the heat sink on the aixiz module, does it matter how far up it is? Like, should it be almost even with the focus grip, or can it be a bit farther back since I have fat fingers?

Thanks,
-Shammi
 





If you are using a full body heatsink, it has to be flush because the driver's spring will not reach the battery.
 
Its not full body, its like a cm (give or take a few mm)... Its just the standard DarkHorse one. Like, do I want it more towards the front of the diode, more towards the back, or should I just try to center it over it as best I can?

Thanks
-Shammi
 
Shammikaze said:
Its not full body, its like a cm (give or take a few mm)...  Its just the standard DarkHorse one.  Like, do I want it more towards the front of the diode, more towards the back, or should I just try to center it over it as best I can?

Thanks
-Shammi
Oh...
In that case, it doesn't matter ;)
 


Back
Top