- Joined
- Jan 8, 2009
- Messages
- 3,144
- Points
- 83
Here is a Harbor Freight mini build... I used a LOC set at 390mA. Glass lens
It uses 3 button cells. I originally wanted a PHR there, but was unable to source a 10280. Hope you like it. jander6442:beer:
I chopped the top of an Aixiz module and pressed it into the host top
then using a flex V5 mounted the diode to the driver.
I usually try not to use a o-ring in my builds... looking for that extra space what can you do.
Side note: The white material is "mighty putty"
works great for driver diode interface material... hardy
able to be sanded or cut ( I use an hobby knife and angular cuts) to fit inside the Aixiz mod. It is great for heat exchange and is non conductive.
Run time should be in the 20-30 min range at 1 min intervals. Thanks for looking.:beer:jander6442
It uses 3 button cells. I originally wanted a PHR there, but was unable to source a 10280. Hope you like it. jander6442:beer:
I chopped the top of an Aixiz module and pressed it into the host top
then using a flex V5 mounted the diode to the driver.
I usually try not to use a o-ring in my builds... looking for that extra space what can you do.
Side note: The white material is "mighty putty"
works great for driver diode interface material... hardyable to be sanded or cut ( I use an hobby knife and angular cuts) to fit inside the Aixiz mod. It is great for heat exchange and is non conductive.
Run time should be in the 20-30 min range at 1 min intervals. Thanks for looking.:beer:jander6442
