Groove2 buck driver

[Flaminpyro]

I have a limited supply of Groove2 drivers, these are buck drives so they
require 2 cells for power, they are rated to 500mA out with no heat sink.
They are $14.00 each plus shipping and PP fees.


Groove2 drive



If you would like to have 2 or 4 each silicone insulated
leads soldered to your driver use this button>
Silicone insulated leads



If you would like the current set on your driver use this button and leave me your current set
point in the instructions to merchant section, remember only Adj drivers can be set>
Current set


Contact Boards in 16.8 and 20mm diameters.



16.8mm contact board


16.8mm contact board w/spring


16.8mm contact board w/leads


16.8mm contact board w/spring & leads


20mm size is on the way
................................

 

[ru124t]

Jeff,I never got a chance to tell you but thanks man. Those contact boards were a breeze to put into my c11 side clicky host! Also, the quality is most excellent! I also have used the soldering kit you make me up and you are correct! Your solder and flux blows away anything I sell at work or could buy at radio shack, actually not radio shack here in Canada its known as the source! lol Thanks again for making this noob feel like he knows what he is doing!