fs: host with custom heatsink

[jake21]

i have here is a host for and kind of diode u want to put in it, it measures out to be 3 inches long asking $20.00

 

[thesk8nmidget]

what kind of batteries does it take? and can you take another picture?

 

[jake21]

it has a 3aaa holder in it, and also it comes with a top half of a axiz modual built in

 

[jake21]

or trade for few drivers ???

 

[Spyderz20x6]

or trade for few drivers ???

Would you trade it for a Rckstr adjustable driver, and a 200mA fixed output driver (original that can take up to 16 volts)? I have these lying around, and have never got through to using them.

 

[iohutom]

Hi,

Is there something connecting the battery holder to the top part like a spring or what? So I can just solder a wire on it and connect to a driver board. Also, is it that the bottom part of the axaiz module already pressed into the heatsink, so that I can just screw the top part with optics on it?

Thanx,
Tom

 

[jake21]

yes it has a flat surface thing with a spring on it, and it has a top half of the axiz modual built in the heatsink, so u can just pop a diode in and ut good to go, and Spyderz20x6 i would but i would like thim all to be for bluray diodes so 150ma to 170ma

 

[Spyderz20x6]

yes it has a flat surface thing with a spring on it, and it has a top half of the axiz modual built in the heatsink, so u can just pop a diode in and ut good to go, and Spyderz20x6 i would but i would like thim all to be for bluray diodes so 150ma to 170ma

The first one (adjustable) is set to 150mA...