Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

Finally done it (back again)






Re: Finally done it

Simply put it adjusts it's self automatically, if you put in 7.2v (it needs 4.5v to run) it knocks it down to what the LD needs (~2-3v) and  the rest is dissapated as heat. You use the resistors and pot to control current.

Oh and if you are buying at RadioShack they have different looking "chips" that are all the same in the LM317T pack so far I have two different looking ones but they are the same, just different makers. The cardboard package clearly says LM317T so don't worry if you get two that don't look like each other. If you don't understand I'll post pics tomorrow.
 
Re: Finally done it

ok becuase the ones i got have like top rounded corners and notches in the sides
 
Re: Finally done it

Like so:
103_0740.jpg

I have 1 like this and 1 squared. Look really close under semi-bright light and they are marked LM317T.
 
Re: Finally done it

No problem man. If you need anything else just let me know.
Good Luck.
 
Re: Finally done it

well i got the lm317t and hocked it up i am using like the same battery ass u but the driver is only putting out a maxe current of 234mA



EDIT:
acyually mines is a 7.2v 1100mah
 
Re: Finally done it

Tolerances of resistors can change some so that sounds right to me. It won't max over 250ma and kill your diode.
 
Re: Finally done it

which laser diode are you gonna use?
If it is a stonetek 16x sony, no need to.
 
Re: Finally done it

well i kinda want to use a hightechdealz 20x
but if i have to use a 16x i will
 
Re: Finally done it

20x will be ok at that level too, and I will find the roundup and post it
 
Re: Finally done it

also my circuit is still like putting out 6-7v but u said early it should be putting out 3-4v
 
You must log in or register to reply here.


Back
Top