Hey guys,
during my first 2 runs of laser harps, I had quite a few people come to me asking if I could make them directly ILDA compatible.
Well, I am considering doing another run of fully assembled, ILDA compatible laser harp controllers.
You would simply plug it into your laser projector, give it some power (Most likely mains power), plug in your MIDI device, and set the sensor up infront of you. No assembly or electrical knowledge required.
Again, this is just a feeler to see if anyone is interested. I am working on my laser cutter at the moment, so will probably have custom enclosures for them and everything.
Cheers,
Dan
during my first 2 runs of laser harps, I had quite a few people come to me asking if I could make them directly ILDA compatible.
Well, I am considering doing another run of fully assembled, ILDA compatible laser harp controllers.
You would simply plug it into your laser projector, give it some power (Most likely mains power), plug in your MIDI device, and set the sensor up infront of you. No assembly or electrical knowledge required.
Again, this is just a feeler to see if anyone is interested. I am working on my laser cutter at the moment, so will probably have custom enclosures for them and everything.
Cheers,
Dan
op: