pwnstar, yes dude. I used Eagle (cadsoft) and a little photoshop.
Childo: You r right and I know too... I welded the capacitor before of this board, and to to test the board, i welded it there temporily.
I Have a circuit very similar to this except I use an smd capacitor and silicon diode.
BTW this looks nice and will help new comers you should make some and sell them.
Thanks I have been looking for a mask like this. I imported into Word and re-sized . When I printed it out the pin holes line up correctly for me. I saved it as a PDF and attached it to the post, hopfully it will scale the same, no guarantees but hope it may help others getting a trace for making a PCB. For some unknown reason I could not open fred_DASP .RAR file to get his PDF.
That'd probably be because this thread is two years old.
Normally, it's considered bad form to bump such old threads, but in this case, you've made a valuable contribution. Thanks! I've actually been meaning to etch some PCB's for drivers, and this helps a lot.
I usually fiddle around with experiments boards - but i dont make them by the dozen either. Its nice if you have time to do etching, drilling and all, but rarely worth it to me with these.