Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

Can I make 2 contacts on my test load?






i am using a diy testload with three wires for the DMM. one "ground" one for the red after 4 diodes and one for the blue after all 6 diodes. works fine so far, you have to pay good attention where you measure the current to not blow your LD... :)
 
Rasser said:
Hello.

Can I make 2 contacts on my test load so I can switch between blu-ray and red?
Or could it be I measure wrong then?

Like this:
http://www.scrallar.dk/albums/userpics/10001/switch-on-dummy.JPG
Click to expand...

On your drawing...
If you jumper the Top Switch (and remove it) and only use the Bottom Switch...

The Test load would be set up for Blu-Ray LDs with the Switch in the Open position
and the Test Load would be set up for Red LDs with the Switch in the Closed position.. ;)

Jerry
 
Rasser said:
Okey so I can do it like this
http://www.scrallar.dk/albums/userpics/10001/switch-on-dummy1.JPG

And when the switch is "on" it is the blu-ray I can measure
And when the switch is "off" it is the red I can measure

Is that right understood?
Click to expand...

No... do it exactly opposite (you removed the wrong switch and jumped the wrong contacts)
if you want the switch to function as I have posted... 8-)

The way you have it now... the switch will do absolutely nothing in either position... :o

BTW... the 2 contacts that you jump... must touch each other...


Jerry
 
Yeah, technically, you can just leave the "BLU" pads soldered and connect/disconnect the "RED" pads to switch between the voltages, but I put both on there to make it more easily understandable... otherwise I'm sure I'd get confusion over how to set the higher "BLU" voltage.
 
Rasser said:
Hmm then I dont think I understand the circuit, but that does nothing, when it works as it should  ;)


New drawing. Then it is like this?
http://www.scrallar.dk/albums/userpics/10001/switch-on-dummy2.JPG

When the switch is "on" it is the red I can measure
And when the switch is "off" it is the blu-ray I can measure

Is that right?
Click to expand...

Yeah... now you got it...
The two pads (BLU) where the switch was before...
should be jumped or have a wire between them... (they should touch each other) ;)

@rkcstr... your Test Load is very versatile and easy to use... [smiley=thumbsup.gif]  Maybe I'm missing something..
              but is the "RED" tap on the Diodes only after 3 diodes...(from what I can see on the
              photo)... I thought the Red LDs needed 4 diodes in series... :-? I may be going blind.. ;D


Jerry
 
Yes, on mine it is 3 diodes for RED and 6 for BLU. i use a diode that has higher Vf than most diodes, being close to 1V at the currents typical for red diodes and a little lower at lower currents, like for the blu-ray diodes. So, the output voltage come out to slightly over 3V for the RED and somewhere around 5V for the BLU range, varying with the actual current running through them, of course.
 
You must log in or register to reply here.


Back
Top