I got the Laser delivered new from LPS after i ordered 2 of the h-series 1.6w lasers. But one of them had a damaged screw on cap that is the natural one without starry glass. So in good faith i got a alternative deal made sending the whole broken laser set back and paying a bit less for the same new pointer in the 3w version. That was delivered good and functioning fine except for the fact that the batterus that come included inside it were seemingly stuck in there. Tried all kinds of things to get them out while i later found oit what it really was. The moment it was turned opened upside down the battery's come out but only the 1st fell out instantly, the seccond bottom one needed 10 to 30secconds upside down to finally fall out aswell lolz... but after i knew that was the case i just accepted that and lived with it. BUT NOW THE REAL PROBLEM. I lost one of the 2 blue 3.7 standard truefire(or whatever) 16340 batts. And ordered 1 new batt from another brand and tiny bit less Volt of 3.6 total.. i was told 3.7 or less should be no problem only the lasers output aka performance w0uld be then having the lower of the 2 as Voltage / output - performance. That all seemed to be working fine. But slowly started to do nothing when turning it on that became from just glitching once a while to many uses later practically not doing much anymore at all. Only works when after i turn it on also keep screwing the batt lid open closed both directionz for a while to see it go on off etc etc .
Any idea what the exact problem is im having here,?,
Any idea what the exact problem is im having here,?,